I think you will be very pleased with it! When doing a larger project with dozens to hundreds of fasteners, a driver is so much easier wrt fatigue than a drill. The chuck is awesome as well ... SO much quicker. I use the bits designed for impact because they will break regular bits faster, but in my experience not enough to justify the cost unless its the bits you use the most often. T20, T25, 1/4, 5/16 etc. Those, I buy the quality ones because they end up being cheaper in the long run.
Hope you enjoy yours as much as I have enjoyed mine! Would be cool to see some before/after pictures.
Thanks for the input, @G-VilleTider ! Took your advice and ordered a 15 piece set of the T25 2" long bits that I use for the Deck mate screws. Should be all set for now.








